Sinden Troubleshooting

Multiple Monitors

Full Multi Monitor setup guide

1. First you need to figure out the total width of your combined monitors in pixels - in this example this is 1920 + 1920 + 1280 = 5120
2. Then you calculate the ratio for the monitor you're going to be playing on - in this example this is 1920/5120=0.375
3. That's your X Ratio on the cursor offset tab - We recommend entering this in the custom 1 row on the bottom left
4. The X Offset depends on which monitor you're playing on - in this example we will be using monitor 2 so we need to basically skip the first monitor which is 37.5 (note this is basically the number from the Ratio times 100)
   1. if we was using monitor 1 to play, the offset would be 0
   2. if we was using monitor 3 to play, the offset would be 2 * 37.5 = 75
5. Through trial and error with different games, you'll figure out which ones need the X Offset and X Ratio to be set... it's easy to switch between values using the custom buttons

Guns with Same ID

If you have 2 guns with the same ID you will need to reflash the firmware on one of the guns. This can be done within the Sinden Software from v1.06 onwards

• Highlight the Lightgun you require to change and hit the 'Select' box
• Select a new ID from the bulleted list (Red-Blue-Black or Player2)
• Hit the 'Update Firmware' button

READ THE WARNING and DO NOT UNPLUG YOUR GUN

Note You may need to manually reinstall the Windows driver.